Recent content by heeman

27.5" The center of the tweeter is about 39" from the floor when on the stands I built for these.

These weigh 41lbs without the drivers.

Sanding, spot putty and sanding..... Ready for paint. Flat paint on the back and sides. Satin on the baffle and baffle edges.

Drilled the pilot holes for the driver hardware. 2 coats of primer/sealer.

Fluffing up the wool and weighing. I figured it would take an hour........not quite. 3.5 hours later!!!

Marked driver mounting holes.

Can you tell us what the issue was with the JVC laser vs the Epson? Thanks!

Considering the C1's were $8K/pair these should be killer for the money. Without Franklin's design skills this would not be possible. Also the ability to tune them specifically to my excellent room, the results should be amazing.

I am all set, thanks Chuck!

I am into this $3200. That includes 2, MiniDSP 2X4HD. Madisound was $2900 of that.

This will be an MTM Design using the Ultra-Low Distortion Purifi Midrange drivers and Morel TSCT Tweeters. Active crossovers. MiniDSP 2X4HD. My Parasound Halo A21 will drive the midrange. (This is currently driving the C1's) I am taking a high current class A/B, 80W/channel amp out of...

Progress continues.......

Big step today! Glued the tee-pee's to the back of the baffle. Prior to this, I connected the wires for the midranges. I needed to get them straight and centered. The level was clamped in place to give me a straight edge on one axis at the correct distance. I lined up the tee-pee's and...

Clearance for the connections/wires.

Rick