Search results

Well, I am done painting. Could I keep going? Yes. They look very good. Being that they will be in the dark theater any additional improvements will not be seen.

Fiberglass, GPO 3 My friends in CA own a transformer/magnetics company. They use this L Shaped and also sheet forms in their products. I asked them to send me a few pieces of L Shaped for the terminal block brackets. It's going to work well.

Sanding and painting continues ....... Making terminal block brackets.

I enjoy some of Paul's videos. They are short and to the point. I don't always agree, especially with his cable opinions.

Keep being productive. Got the tweeter wires out from behind the wall. Got them cleaned up and ready to go!

Second coat of paint on the baffles. 16 hours between coats. Tomorrow I will sand and give them the third coat.

2 coats of flat black on the backs. Tomorrow my plan is to get the first coat on the baffles.

(27.5") actually 28.5" The center of the tweeter is about 39" from the floor when on the stands I built for these.

These weigh 41lbs without the drivers.

Sanding, spot putty and sanding..... Ready for paint. Flat paint on the back and sides. Satin on the baffle and baffle edges.

Drilled the pilot holes for the driver hardware. 2 coats of primer/sealer.

Fluffing up the wool and weighing. I figured it would take an hour........not quite. 3.5 hours later!!!

Marked driver mounting holes.

Can you tell us what the issue was with the JVC laser vs the Epson? Thanks!

Considering the C1's were $8K/pair these should be killer for the money. Without Franklin's design skills this would not be possible. Also the ability to tune them specifically to my excellent room, the results should be amazing.

I am all set, thanks Chuck!

I am into this $3200. That includes 2, MiniDSP 2X4HD. Madisound was $2900 of that.

This will be an MTM Design using the Ultra-Low Distortion Purifi Midrange drivers and Morel TSCT Tweeters. Active crossovers. MiniDSP 2X4HD. My Parasound Halo A21 will drive the midrange. (This is currently driving the C1's) I am taking a high current class A/B, 80W/channel amp out of...

Progress continues.......