Search results

More subs you asked and you should receive. Added two JBL MR818 for subs to the pair of scoop subs on the outside system. the TL15-1 with the JBL 2226 was also used but attached to the mids. 12 inch 2 way. So system was pumping 800 a side into the scoop's and MR818. and the Mids 12 inch...

On another note about plate amplifiers and DSP. Some of these in the past have some DSP processing to allow for good control and good sound. Removing the old amp and putting another in its place would not allow for the DSP processing. However the Part-express DSP is not very much these days...

Leaks or gaps can allow for sound to move from room to room. including vents. there is a resilient mount for the dry wall to isolate the dry wall from the studs to prevent vibration. there is also a type of drywall for noise deadening. rearrange the room to move his desk to the farthest...

:):):)

that would lead to edge diffraction issues. most people will not be able to detect this by ear alone. They use an EV ST35 driver brother to my ST350B driver.

https://worldradiohistory.com/Archive-All-Audio/Archive-Audio/50s/Audio-1958-May.pdf https://worldradiohistory.com/Archive-All-Audio/Archive-Audio/60s/Audio-1963-05.pdf page 7 ? https://worldradiohistory.com/Archive-All-Audio/Archive-Audio/70s/Audio-1979-03.pdf Turn table cartridge ? check...

https://worldradiohistory.com/index.htm

These cheap plastic ones come with some of the gear but not great.

as long as one side matches the other side you should be good. Look up 586a and 586b.

I think that it has two backs and the silica was between the two backs

one on left, two in center and one on right creating two desks side to side. With the tops from the same company.

wife picked them for our office. We have 1, 2, 1 and the tops works well.

I have found that the mono center image to be very good. But this was using the home built version that does not have the signal attenuation for the out of phase opposite side. My crossover was around 200 to 260 hz for the bass module to the 4 inch drivers I used as midrange.

one thing they did not address in the white paper is the first reflection points and the acoustics of the room. The setup is assumed to work in Near Field Monitors and the room acoustics not being addressed.

I have the original white paper explaining the principal. To large to share, I can email to you. The one thing it does not address is the room acoustics and the first reflections.

Yes and in the movie Contact it was just Science, The tape did record 16 hrs of static. The person only dropped from top to bottom in less than a second or two. yes movie majic

If in doubt you and if the space allows you can build a small roof car port to place over the speaker cabinet with a piece of construction plastic on top to keep the water off the speaker cabinet. 2x2 as legs. plywood top with plastic on the top as shingles.

If your in the fireplace the flue can possibly allow moisture and rain in. So as long as your not seeing wet you should be good. With the front port you have the space in the room. however on rear port you need the space behind to all the sound to build and come around and into the room. The...