So there has been an itch to scratch after learning so much about this hobby and on our 3rd Home Theater in a decade.
Retirement has been treating me very well.
My current system performs extremely well mainly because of what I have been able to do with optimizing my dedicated room acoustically.
After Franklin built his Ellipticor MTM's, I have been consulting with him on and off about how to improve on the clear, detailed sound that can perform better the Dynaudio C1's that are currently my main speakers.
Well, I have been working with Franklin on a design, the drivers have been purchased and the MDF cutting should start later this week!
This will be an MTM Design using the Ultra-Low Distortion Purifi Midrange drivers and Morel TSCT Tweeters. These will be paired with my existing Scan Speak Revelator Woofers that I built a few years back that was well documented on this forum.
If there is interest here, I will do my best to document this project.
I am sure that Franklin will chime in here at some point.
Retirement has been treating me very well.
My current system performs extremely well mainly because of what I have been able to do with optimizing my dedicated room acoustically.
After Franklin built his Ellipticor MTM's, I have been consulting with him on and off about how to improve on the clear, detailed sound that can perform better the Dynaudio C1's that are currently my main speakers.
Well, I have been working with Franklin on a design, the drivers have been purchased and the MDF cutting should start later this week!
This will be an MTM Design using the Ultra-Low Distortion Purifi Midrange drivers and Morel TSCT Tweeters. These will be paired with my existing Scan Speak Revelator Woofers that I built a few years back that was well documented on this forum.
If there is interest here, I will do my best to document this project.
I am sure that Franklin will chime in here at some point.
